1.) Myofibs need a reduction. Instead of 15%, the might be booting jump height by 115%

2.) Large Missiles need buff- they are bad at killing vehicles. They either need their 400 RoF back or 300 RoF with 16 Clip. Or 200 RoF with 20 Clip.

3.) Armor Hardeners need a nerf. (5% would do) Armor tanks are back to 1.7 level with ridiculous rep rates and a 40% hardener on top of that.

4.) LAV's need more slots.

5.) All tanks need more CPU/ PG, with more slots comes more fitting problems. My proto Gunnlogi's low slots are full of proto fitting modules and I still cannot fit a full proto tank with proto gunner slots and proto filled high slots

6.) Is there a reason that a heavy shield booster takes up 40% of all the PG on my Shield tank?

7.)Turrets need to be looked at. All Missile turrets cost way more CPU and PG than railgun and blaster turrets.

8.) Tanks per side on map needs to be looked at. 5 HAV's per side is too much Rattati.

9.) Some of the turret modules are very hard to fit but useless at Standard level.

10.) Hardeners need to be balanced in another way. There shouldn't be a cap but there also shouldn't be a boosted fitting cost. The players that use only one hardener shouldn't be penalized like the rest The Fitting cost of a Hardener is too much, they take up a good 35% of my CPU on my Shield tank. Their CPU and PG needs to go back to the way they were.

Instead of current hardener balanced around CPU/PG, I suggest we balance it around efficiency. What if we made it so that if you activate two hardeners at one, the second hardener will only have 25% efficiency. This would make it so that if you activate two shield hardeners instead of one, your efficiency goes from 40%->50% resistance.

I really dislike being penalized especially since I only use one hardener.

Also- The AScR melts shields wayyyy too fastttttttttttttt. I lost my 640 shields on a Cal Sent (just a level1) to a standard Amarr commando with a Basic Assault ScR in like 1 sec.