Pages: [1] :: one page |
|
Author |
Thread Statistics | Show CCP posts - 3 post(s) |
Harpyja
DUST University Ivy League
951
|
Posted - 2013.12.23 21:09:00 -
[1] - Quote
I kicked up my modules prior to engaging an enemy blaster armor HAV, and when I spammed R1, only one missile came out and I was stuck on 11/12 missiles in the clip. I sat there reloading while the HAV was slowly chipping away at my shields, though to not much effect. When I was reloaded, I tried firing again and this time not a single missile flew out.
At this point I just casually drove past him and went for my redline to figure out what was going on. A few more unsuccessful attempts to fire my missiles was made before they finally became "unjammed."
"By His light, and His will"
- The Scriptures, Gheinok the First, 12:32
|
|
CCP Delamorui Eddy
C C P C C P Alliance
57
|
Posted - 2013.12.24 06:01:00 -
[2] - Quote
Hi, thank you for contacting us.
There is a known issue that if you shoot in a tank and you activate a scanner at the same time, sometimes your tank will refuse to fire. Is this what it happened?
Thank you.
|
|
Harpyja
DUST University Ivy League
952
|
Posted - 2013.12.24 06:06:00 -
[3] - Quote
CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
There is a known issue that if you shoot in a tank and you activate a scanner at the same time, sometimes your tank will refuse to fire. Is this what it happened?
Thank you.
Thanks for the response. Unfortunately, I wasn't using an active scanner at all. I had an active hardener and damage amplifier, both of which were activated prior to shooting.
"By His light, and His will"
- The Scriptures, Gheinok the First, 12:32
|
Aeon Amadi
Ancient Exiles. Renegade Alliance
4211
|
Posted - 2013.12.25 01:48:00 -
[4] - Quote
Found a work-around. Switch turrets and it'll allow you to fire, at least.
Video Link: http://www.youtube.com/watch?v=wwtQttKhZaQ
forums.dust514.com/default.aspx?g=posts&m=
(Frames)1544109 (Advertisement)1556863 (Packs)1570030
(Lag Hunt) 1570201
|
|
CCP Delamorui Eddy
C C P C C P Alliance
60
|
Posted - 2013.12.26 06:09:00 -
[5] - Quote
Harpyja wrote:CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
There is a known issue that if you shoot in a tank and you activate a scanner at the same time, sometimes your tank will refuse to fire. Is this what it happened?
Thank you.
Thanks for the response. Unfortunately, I wasn't using an active scanner at all. I had an active hardener and damage amplifier, both of which were activated prior to shooting.
We have reproduced it by shooting when activating a hardener. The Dev team will work on the fix. Hardener and scanner are known issues, if there are other modules that have the same problem, please let us know.
Thank you.
|
|
Harpyja
DUST University Ivy League
957
|
Posted - 2013.12.26 06:12:00 -
[6] - Quote
CCP Delamorui Eddy wrote:Harpyja wrote:CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
There is a known issue that if you shoot in a tank and you activate a scanner at the same time, sometimes your tank will refuse to fire. Is this what it happened?
Thank you.
Thanks for the response. Unfortunately, I wasn't using an active scanner at all. I had an active hardener and damage amplifier, both of which were activated prior to shooting. We have reproduced it by shooting when activating a hardener. The Dev team will work on the fix. Hardener and scanner are known issues, if there are other modules that have the same problem, please let us know. Thank you. Cheers! \o/
"By His light, and His will"
- The Scriptures, Gheinok the First, 12:32
|
|
CCP Delamorui Eddy
C C P C C P Alliance
66
|
Posted - 2013.12.27 07:28:00 -
[7] - Quote
Hi, thank you for contacting us.
It seems to be that weGÇÖve missed damage amplifiers. It will be updated for 3 modules - Hardeners, scanners and amplifiers.
Thank you.
|
|
Aeon Amadi
Ancient Exiles. Renegade Alliance
4223
|
Posted - 2013.12.27 07:39:00 -
[8] - Quote
CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
It seems to be that weGÇÖve missed damage amplifiers. It will be updated for 3 modules - Hardeners, scanners and amplifiers.
Thank you.
So all active modules =P
Better check fuel injectors just to be sure. Will do that now.
forums.dust514.com/default.aspx?g=posts&m=
(Frames)1544109 (Advertisement)1556863 (Packs)1570030
(Lag Hunt) 1570201
|
Aeon Amadi
Ancient Exiles. Renegade Alliance
4223
|
Posted - 2013.12.27 08:08:00 -
[9] - Quote
Yup! Fuel Injectors/Afterburners will trigger it as well =D
http://www.youtube.com/watch?v=o4UXpVVTZ9U&feature=youtu.be
forums.dust514.com/default.aspx?g=posts&m=
(Frames)1544109 (Advertisement)1556863 (Packs)1570030
(Lag Hunt) 1570201
|
Harpyja
DUST University Ivy League
966
|
Posted - 2013.12.27 14:08:00 -
[10] - Quote
Wow, thanks for your work Aeon
"By His light, and His will"
- The Scriptures, Gheinok the First, 12:32
|
|
Beyobi
Resheph Interstellar Strategy Gallente Federation
125
|
Posted - 2013.12.30 19:30:00 -
[11] - Quote
I had a similar effect while I was using a Rail Turret Installation. I was in a Domination Match, on Fracture Road while using the rail turret in map section F5, I would noticed it would 'jam', I was puzzled. Then I noticed that if one of the support structures (around F5,G6 area) was in the sightline of the turret, the turret would not fire. Maybe the structure is an Invalid target? Perhaps this is why the turret won't fire? |
KEROSIINI-TERO
The Rainbow Effect
925
|
Posted - 2014.01.01 06:26:00 -
[12] - Quote
Have had the same effect often with blasters.
Most often just prior to engaging a red tank (fits with active module activation) and on many occasions the red tank was on sligthly higher elevation, like uphill road. Weird. On one instance the red tank was climbing on top of me and turret ceased to function.
Tank spam getting onto your nerves?
An improvement:
|
Timothy Reaper
WASTELAND JUNK REMOVAL Top Men.
674
|
Posted - 2014.01.01 08:10:00 -
[13] - Quote
This is so nice to see! People calmly inform CCP of a problem, CCP responds asking for more infomation and people calmly provide more info. It brings a tear to my eye. :') If only this happened more often.
Never argue with stupid people, they will drag you down to their level and then beat you with experience.
Mark Twain
|
Lorhak Gannarsein
992
|
Posted - 2014.01.01 10:46:00 -
[14] - Quote
CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
There is a known issue that if you shoot in a tank and you activate a scanner at the same time, sometimes your tank will refuse to fire. Is this what it happened?
Thank you.
This one is for all modules, not just scanners, for what it's worth.
PRO tanker and proud.
Lentarr Legionary.
|
ladwar
Death by Disassociation Legacy Rising
1947
|
Posted - 2014.01.01 11:53:00 -
[15] - Quote
CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
It seems to be that weGÇÖve missed damage amplifiers. It will be updated for 3 modules - Hardeners, scanners and amplifiers.
Thank you.
hey have you found out why missiles don't stay full auto(hold and it will fire) and they switch to semi auto(click everytime).
Level 2 Forum Warrior, bitter vet.
I shall smite Thy Trolls with numbers and truth
not looking for a corp, don't ask.
|
Benjamin Ciscko
The Generals General Tso's Alliance
1074
|
Posted - 2014.01.01 18:58:00 -
[16] - Quote
Same with blaster I saw a shield rail activated my hardener shot at him... or so I thought it refused to fire full ammo no heat build up.
Tanker/Assault
Can I have my ADV and PRO tanks now (Honeyed Lamb enroute).
Forum warrior lvl 1
|
Harpyja
DUST University Ivy League
997
|
Posted - 2014.01.01 19:05:00 -
[17] - Quote
ladwar wrote:CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
It seems to be that weGÇÖve missed damage amplifiers. It will be updated for 3 modules - Hardeners, scanners and amplifiers.
Thank you.
hey have you found out why missiles don't stay full auto(hold and it will fire) and they switch to semi auto(click everytime). I'd like to know as well since I'm getting tired of spamming R1 for every engagement (because I don't want to lose valuable time in the case full-auto stops on me halfway through the clip).
But I believe that deserves its own thread (and I believe there is one somewhere) as I think it's an unrelated bug.
"By His light, and His will"
- The Scriptures, Gheinok the First, 12:32
|
Benjamin Ciscko
The Generals General Tso's Alliance
1077
|
Posted - 2014.01.01 19:11:00 -
[18] - Quote
Harpyja wrote:ladwar wrote:CCP Delamorui Eddy wrote:Hi, thank you for contacting us.
It seems to be that weGÇÖve missed damage amplifiers. It will be updated for 3 modules - Hardeners, scanners and amplifiers.
Thank you.
hey have you found out why missiles don't stay full auto(hold and it will fire) and they switch to semi auto(click everytime). I'd like to know as well since I'm getting tired of spamming R1 for every engagement (because I don't want to lose valuable time in the case full-auto stops on me halfway through the clip). But I believe that deserves its own thread (and I believe there is one somewhere) as I think it's an unrelated bug. I have never actually gotten full auto I always spam the R1 button when I run missiles.
Tanker/Assault
Can I have my ADV and PRO tanks now (Honeyed Lamb enroute).
Forum warrior lvl 1
|
|
|
|
Pages: [1] :: one page |
First page | Previous page | Next page | Last page |