|
Author |
Thread Statistics | Show CCP posts - 0 post(s) |
Awry Barux
Shining Flame Amarr Empire
37
|
Posted - 2013.09.09 19:03:00 -
[1] - Quote
Disclaimer: This is a pub guide for lone wolf players. This isn't for hardcore squad play or PC in any form. Some critical changes in 1.4 have had a drastic effect on the pub metagame. Specifically: -No more shared squad vision -Powerful auto-aim (I'm not going to commentate on it being good or bad. At this point we have to accept it.)
Effects of these changes: Everyone and their mother is rolling with active scanners now. 95% of pub matches I've played since the patch have had at least 1-2 scanners on each team, meaning that most people on most teams are scanned most of the time. Scanners are deadly, because they show facing in addition to position, for anywhere from 5 to 25 seconds. However, due to high fitting requirements, the vast majority of people only run STD, which has 46db scan precision. Auto aim and lowered strafe speeds mean that you can no longer just out-strafe a whole squad. Everyone in a pub can be relied upon to lay down solid DPS, once they can see the enemy. Basically, the current pub metagame and patch state are turning Dust into a game of perfect information. Unless you play the EWAR game, it's all going to come down to EHP vs DPS, every single time. This is not a good position for anyone with <10 million SP. In terms of pub play styles, this means that by and large every match plays out as the AR Ball. The (majority of the) two teams set up ~50M away from each other and go for AR/LR picks until the match is over.
So, that's the state of the game, and it's a little boring. Now what? How should our tactics change? Flanking is now critical, both because scanners have at most a 60 degree scan zone and because no shared vision means that as long as you don't ping (hit w/ 1 bullet) anyone else by accident, you can pick off stragglers without alerting the entire enemy team. Using a LAV to sneak ~200M behind enemy lines, then running up on them scanning as you go, will pretty much always net you 2+ kills on unsuspecting enemies. The TAC, LR, and AR are all ideal weapons for this purpose, depending on whether you prefer mid-long or semi-cqc. The shotgun is workable but gives you less hit and run ability. The locus grenade is your best friend here, learn to cook and love that 500+ damage alpha. How does this affect fitting logic? Being able to hide from active scans is now far more important than being able to survive 3 extra AR bullets. A single ADV dampener is now by far the most beneficial use of a low slot. This will take an Assault suit's scan profile to <45, and a Logi's to ~37. If you get rank 5 dampeners but use the ADV dampener, it should (my math may be wrong) get a Logi to <36, which is the ADV scanner precision. By the same token, fitting an active scanner for yourself is now equally important. Get ADV for the quantum and stable versions. I could go on for hours but I assume people know to fit an armor repper when lone wolfing, etc. Feel free to reply with questions.
tl;dr: Take any medium suit, slap on an AR, locus nades, profile dampeners, and a scanner. Run or use a LAV to flank and abuse your scanner. Slay noobs and protobears alike with your devious sneak attack. Hit, run, repeat.
Thoughts? Testimonials? Improvements? Critiques?
|
Awry Barux
Shining Flame Amarr Empire
37
|
Posted - 2013.09.09 19:15:00 -
[2] - Quote
Beren Hurin wrote:You get that if you are running solo, when you scan, only you will see the results, right? That's definitely not the case. I've been in many matches where I'm not in a squad and not running with a scanner, and I get other players' scan data. |
Awry Barux
Shining Flame Amarr Empire
39
|
Posted - 2013.09.10 19:00:00 -
[3] - Quote
Fox Gaden wrote: As far as content feedback, I was under the impression that while the logi suit had a passive scan precession 5 lower (more sensitive) than the assault suit, their scan signature was the same as an assault suit. If I am correct, which I may not be with the rapid pace of change, then a sensor dampener would have the same effect on a logi as on an assault. (Unless that was changed in 1.4.)
You're absolutely right on the scan signatures, and I've updated the guide appropriately. Good catch. |
Awry Barux
Shining Flame Amarr Empire
40
|
Posted - 2013.09.10 20:44:00 -
[4] - Quote
Rogatien Merc wrote:https://forums.dust514.com/default.aspx?g=posts&m=1195716#post1195716
... pre-1.4, but applies with the only update being basically "fit a scanner".
Min Logi is now a very viable option due to ability to drop links, RE, personal hive, and a scanner using a Tac AR... and utilize the scanner and RE to minimize/mitigate CQC threats.
That guide is great! Personally I've been playing the flanker with an ALogi suit. It's distinctly slower, but careful scanning and planned movement can minimize the number of situations where you're forced to sprint away. The main benefit is obviously being able to have both a solid equipment rack (rep hive / scanner / hive) and a sidearm. The SMG works fantastically as a mop-up tool after a good nade ambush. The scanner makes it easy to find time and space to rep up in between fights, making hybrid tanking even better. As a side note, when armor tanking on a flanker, 1 complex plate + 2 ferroscale plates will cut your speed deficit to -2.8% as opposed to -5% by abusing the way stacking penalties are calculated. |
Awry Barux
Shining Flame Amarr Empire
41
|
Posted - 2013.09.11 15:48:00 -
[5] - Quote
Reav Hannari wrote: I believe the DUST client should tell me my current profile and scan sensitivity.
Bahaha. You'd think that, but no. You can only see your suit's base stats for those, not the stats after dampeners/precision enhancers. |
|
|
|